"Flexco Bolt Hinged fasteners ideal for applications that use smaller pulleys, but still required a high-strength, dependable splices. A choice of sizes accommodate belts from 1/4” (6mm) to 5/8” (16mm) thick, and 12” (300mm) to 60” (1500mm) wide."
Recommended Maximum Operation Tension: Up to 400 P.I.W. (70kN/m)
"For belt conveyor applications subject to frequent length adjustments, the Bolt Hinged fastener is easy to install and re-install. On-site installation requires hand or power tools. Our exclusive piloted bolt also simplifies installation and holds fastener plates firmly in place. For added strength and pull-out resistance, specially formed teeth penetrate deep into the belt carcass without damaging carcass fibers."
Steel – standard fastener material is suitable for most applications. Plated for rust and corrosion resistance.
300 Stainless Steel – extra resistance to abrasion, magnetic attraction, and corrosion from acids and chemicals. Also excellent for high-sanitary requirements.
Power Punch - เครื่องมือเจาะรูสายพานเพื่อร้อยน๊อตสกรู (Power Punch is used to punch holes through the belt)
Power Wrench - เครื่องมือขันหัวน๊อตสกรู (Power Wrench is designed to be used in a carpenter's brace, are used to tighten the nuts of the bolt fasteners)
Quick Change Chuck - เครื่องมือหัวจับดอกสว่านไฟฟ้า (To use power tools, a Quick Change Chuck is required to adapt Flexco tools)
Bolt breakers easily break the excess bolt material off after installing Bolt Solid Plate or Bolt Hinged fasteners. Bolt Breakers come two per package.
A rigid nylon tape that helps eliminate belt ripple on plied or solid-woven belting, so belts run smoothly over pulleys and under cleaners. Used with Bolt Hinged and Bolt Solid Plate Fasteners. Also helps seal the splice against seepage of fines and moisture.